Camco D-POWER 3 Manuel d'utilisateur télécharger pdf (Page 12)

12 / 42

www.camcoaudio.com

USER MANUAL

Q-POWER 14

POWER AMPLIFIER

MAINS SUPPLY

3. Mains

3.1 Mains Supply

The Q-POWER 14’s power supply is a true wide-range SMPS with active power

factor correction (PFC). This means that it can be operated anywhere in the

world without the need of any manual voltage range setting.

When mounting or connecting the amp always disconnect it from mains. Only

connect the Q-POWER 14 ampliﬁer to an appropriate AC circuit, according to the

requirements indicated in the second line on the rating plate.

3.2 Mains Plugs and Cables

Only use mains cables with original Neutrik

powerCON

32 A connectors for

safety reasons.

NOTE

Please never unplug the powerCON

cable from the amplier while it is still

carrying live voltage. Even if the amplier is switched off!

Unplugging must always be done on the other end of the mains cable (i.e. with

the wall outlet plug*, or by the installation circuit breaker(s)).

The reason ist that the powerCON

connector is not designed for disconnecting

live voltages, as this might deteriorate it’s contact performance over time.

* provided the connector is suited as a disconnect device, as for example the “Schuko”

plug used in Europe or the Twist-Lock plugs used in North America

NOTE

Please make sure to always use appropriate mains cables and wall outlet

plugs offering sufcient current rating.

See also chapter 3.7 for more details on current rating and circuit breaker selection.

And of course do never remove the protective earth conductor, under any cir-

cumstances. The Q-POWER 14 must always be connected to a socket with a

protective earth connector.

! WARNING

DO NEVER REMOVE OR DISCONNECT THE MAINS GROUND/EARTH

CONNECTION. IT IS ILLEGAL AND DANGEROUS!

3.3 On / Off Switch

The On / Off Switch is a rocker-type switch. It is located on the right side of

the front panel. To turn the ampliﬁer on, press on the upper part of the switch.

During power up the Clip- and Signal-LEDs of all channels will light up in red for

a few seconds. To turn the ampliﬁer off, press on the lower part of the switch.

Ampliﬁer is switched on Ampliﬁer is switched off

NOTE

This switch does NOT disconnect the amplier from mains.

Disconnecting the ampliﬁer from the mains can only be achieved by disconnect-

ing the mains plug or by the installation circuit breaker(s).

The mains plug or circuit breaker(s) therefore have to be freely accessible at all

times. Disconnect the mains plug from the mains during a thunderstorm or when

the ampliﬁer remains unused or unsupervised for a prolonged period of time.

While switched off and still connected to mains, the Q-POWER 14 will have an

average power consumtion of less than 2 W.



   

  

  

Q-POWER 14

100 - 240 V ~ 50/60 Hz 2200 W

3000 W / 2,7 Ohm

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Camco D-POWER 3 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Amplificateurs audio Camco D-POWER 3